Note: The port numbers of the SIN and SOT pins vary with the types of microcontrollers. Then RSTX pin set from Low to High level executes user program. When the RSTX pin is set from Low to High level after setting the MD2, MD1, MD0 pins, the microcontroller enters the serial reprogramming mode, enabling serial reprogramming from the PC.Īfter the reprogramming, control is shifted to the normally-used mode as for MD2, MD1 and MD0 pins. The MD2, MD1, MD0 pins cannot be controlled by the PC and should be set in the user system. EXAMPLE OF CONNECTION FOR ON-BOARD REPROGRAMMING BY PROGRAMMER Note that the user system must have an RS-232C driver for communication with the microcontroller UART. Using RS-232C cable connected to the personal computer (Windows PC), flash memory data in the microcontroller mounted in the user system can be reprogrammed. 18įUJITSU FLASH MCU Programmer for F2MC-16FX Specifications Programmer Functions.7ħ.1 Downloading.8 7.2 Erasing and Programming.10 7.3 Internal motorola S decoder specification.12 7.4 Special specification. Example of Connection for On-board Reprogramming by Programmer. Internal motorola S decoder specifiction is added.ġ. Serial data I/O pins for MB96F326A/R/Y is corrected. If the products and technologies described in this document are controlled by the Foreign Exchange and Foreign Trade Control Act established in Japan, their export is subject to prior approval based on the said act. For such applications, contact your Fujitsu sales representative.ħ. The products described in this document are not intended for use in equipment requiring high reliability, such as marine relays and medical life-support systems. No part of this publication may be copied or reproduced in any form or by any means, or transferred to any third party without prior written consent of Fujitsu.Ħ. Fujitsu reserved the right to change products or specifications without notice.ĥ.

The information contained in this document does not convey any license under the copy right, patent right to trademarks claimed and owned by Fujitsu.Ĥ. However, Fujitsu assumes no responsibility for inaccuracies.ģ. The information contained in this document has been carefully checked and is believed to be reliable. Complete information sufficient for construction proposes is not necessarily given.Ģ. Circuit diagrams utilizing Fujitsu products are included as a mean of illustrating typical semiconductor applications. Version 1.03 26 March 2008 Software version: V01L04Ģ007-2008 FUJITSU LIMITED Printed in Japanġ. MCU Programmer for F2MC-16FX Specifications

Fujitsu 16lx programmer